January 9th, 2009
Hi all, I have an old Delta 36-220C compound miter saw. It recently took a hard fall and broke the part that locks the table into all of the pre-set angles. Delta no longer provides the part. Does anyone have one of these saws with some other problem that makes it non-functioning? I would love to repair the saw but so far no luck.
Thanks in advance
DavidThanks, I hadn't found that site before - the part is marked Obsolete - no Replacement. I have contacted to company to see if that means it is actually available.
Thanks again
DavidYou might look here- http://www.toolpartsdirect.com/cgi-bin/noframes.cgi/delta/36-220_TYPE_III#If you have any other info about this subject , Please add it free.# |
|
Posted in
xn--xhq73t94fv79a.com |
edit
